OUTLAW OFFSET FLM FRAME
 
 
The "FL" design was developed in cooperation with outlaw specialists Finish Line Fabricating of Allegan, Michigan for the "Outlaw" rules of Michigan, Ohio, and Indiana. These chassis are capable of over 64% left side weight at only 2600 pounds depending on components. The FL has a lower main roll bar to allow the back of the roof to be pulled down. The center section has an additional inch of offset and the tail is moved farther left. The FL is available with front panhard only.
 
Item  
Outlaw Offset FLM Frame  
 

 
WELD ON OPTIONS
Item  
Weld On Options  
 
Items Included
Bumpers or Bumper Mounts
Battery Box
Second Drive Shaft Loop
Fuel Cell Guard
Brake Line Tabs
Oil Tank Mounts
Hood Pin Mounts
Body Mounts
 

 
EXTRA OPTIONS
Item  
Fuel Cell Mount - 1" x 1" Bars Only  
Fuel Cell Mount - Two 1/8" x 2" Straps  
Fuel Cell Mount - Four 1/8" x 1-1/2" Straps  
Fuel Cell Mount - Four 1" x 1" Nascar Tour  
Cell Mount - Four 1" x 1" Nascar LMS  
Hard Brake Lines Installed  
Steering Shaft - Manual  
Steering Shaft - Power  
Steering Shaft - Collapsible  
Standard Door Plates  
ASA Door Plate  
 

 
   
 


Copyright © 2004 by FinishLine Fabricating, Inc.
All rights reserved. Please read our Legal/Copyright Notice
Site Last Revised: Wednesday, September 13, 2006 9:02 PM
Phone: 269.686-8400 Fax: 269.686-8694

Web Site Design and Hosting by: CSInet Internet Access Corp.

Web Site Design and Hosting by: CSInet Internet Access Corp.